ARCHIVE

A Review on Optimum Height and Location of Shear Walls in High-Rise Buildings

Authors :  Dipika N. Khandelwal , Monica S. Mhetre Abstract –Shear walls are the structural members designed to counteract the lateral forces acting on a structure in seismically active zones when shear forces on the structure increases due to earthquake loads and/or wing load effect. Shear walls tend to provide substantial strength and stiffness as […]

READ MORE

Finite Element Analysis of M.S. Impeller of centrifugal Pump

Authors : Prof. Pranav R.Mane, Prof. Pankaj L. Firake, Prof. Vijay L. Firake Abstract- Centrifugal pump is a device mainly used for transporting liquid from lower level to higher level.  Centrifugal pumps are widely used for irrigation, water supply plants, steam power plants, sewage, oil refineries, chemical plants, hydraulic power service, food processing factories and […]

READ MORE

Investigation of Critical Regions on Automotive Lower Suspension Arm Using Analytical Approach

Authors : Mr. Abhijit S. Khanapurkar , Mr. Prashant N. Awachat Abstract – This paper focuses on investigating the critical locations of Automotive Lower Suspension of car front suspension to study the stress condition and to select the suitable materials for the front suspension lower arm. In this paper first upon the modeling of Automotive […]

READ MORE

Wind Power Generation Using Magnetic Levitation: A Review

Authors :  Prof.S.K.Malode,Vaishali A. Randive Abstract – The term “Levitation” refers to a class of technologies that uses magnetic levitation to propel wind turbines with magnets rather than with axles and bearings. Maglev (derived from magnetic levitation) uses magnetic levitation to propel wind turbine for the generation of electricity. The present scenario indicates that the […]

READ MORE

An Approach for apply DVR to Moderate Voltage Sags and Swells

Authors : Namrata Gupta , Manish Awasthi, Mahesh Ahuja, Suman Giri Goswami Abstract – Improved and controlled power quality is one of the necessary fundamental in any electrical industry for the utilization of resources. On the other hand critical problems in power quality have been predictable such as sags, swells, harmonic distortions and some of […]

READ MORE

Performance Analysis on Continuous Longitudinal Fins Solar Air Heater

Authors: Prof.  Nilesh R.Pathare Abstract – The power from the sun intercepted by the earth is approximately 1.8 x 1011 MW, which is many thousands of times larger than the present consumption rate on the earth of all commercial energy sources. Thus, in principle, solar energy could supply all the present and future energy needs of […]

READ MORE

Smog-its constituents, Effects &Ways to Eliminate –An Overview

Authors : Shweta Matey , Shanmuganathan Mudaliar, Utkarsh Nalawade , Pratik kadam Abstract-Here we are about to discuss the formation of smog, it’s chemical constituents, the effects of smog not only on human beings but also on vegetation and surrounding environment. Major Air Pollutants responsible for smog are carbon oxides (CO, CO2) , nitrogen oxides […]

READ MORE

RF MEMS Based Tunable Circuit for Wireless Communication

Authors: V.G.Umale , S.N.Ganorkar Abstract-Modern wireless systems have an increasing need for multiband and tunable microwave and millimeter wave components. The Wireless communication system has several tunable circuits, which reduces the number of the circuits, size, and cost of the front-end. The application of micro electromechanical systems (MEMS) technology to RF systems enables production of components […]

READ MORE

Sustainable Approach For Energy Requirement During Construction

Authors : Prerana Shankarsing Rajput , Deepa A. Joshi Abstract – Renewable power generation can help countries meet their sustainable development goals through provision of access to clean, secure, reliable and affordable energy sources. The construction sector significantly uses non-renewable energy. The idea is to check the effectiveness of utilization of the renewable energy sources […]

READ MORE

Application of a Dual Simplex method to Transportation Problem to minimize the cost

Authors : Manisha.V. Sarode Abstract – In this paper the aim of work is to introduce dual simplex method to solve transportation problem with fuzzy objective functions. The Simplex has wide use transportation problem. It aims to minimize the cost of transportation. The fuzzy objective functions have fuzzy demand and supply coefficients, which are represented as […]

READ MORE